In order to "read CTL+C as input" instead of having it generate a SIGINT it is necessary to use tcsetattr() to either clear cc_c[VINTR] or clear the ISIG flag as described in the manual page that I linked to, here.

You will need to use tcgetattr, first, to read the current terminal settings, adjust them accordingly, then tcsetattr to set them.

You should make sure that the terminal settings get reset to their original defaults when your program terminates, it is not a given that the shell will reset them to default, for you.

Nope, signal() is not the way. You should need to configure the tty driver to do raw input (no input char processing in the driver), so it passes all characters untouched. But this requires considering the tty input device as special and write special code to treat that case (this requires you to issue several ioctl system calls). But this is not recommended, for the reasons explained below.

Second, there's another, simpler way that doesn't require to use raw mode. You can escape the Ctrl-C character by prepending the tty escape character. In Linux and BSD system, this is normally tied to the Ctrl-V character, so pressing Ctrl-V + Ctrl-C allows you to input a single Ctrl-C char. I have just checked it with the hd command:

$ hd
^C
00000000 : 03 0a                                           : ..
00000002
$ _

Next question is, then, how to input a Ctrl-V? well, just double it! (but we are out of scope now, just continue reading)

The advantage of this approach is that it doesn't require programming in your program and will work the same way when reading from a file, pipe, fifo, socket, etc. (to which Ctrl-C has no special meaning, as the tty driver is out of scene) The only device that generates an interrupt when detecting Ctrl-C is the tty driver (more exactly, the controlling tty, in it's code generic part, so all ttys do this) and it also has a escape character (by the same reason, all ttys have it) to invalidate the special meaning of the next character.

You can check which character is the escape character with the stty(1) command, configured as the lnext entry. But I can almost ensure you that it will be Ctrl-V.

Note

This also applies to any other special character (like Ctrl-D, Ctrl-H, etc. that the terminal uses for special purposes)